Kendal Lighting RK33G-SN Instruction Manual download pdf

*WARNING:RISK OF FIRE AND ELECTRIC SHOCK.THIS PRODUCT REQUIRES

PROPER FIELD WIRING AND IS INTENDED TO BE INSTALLED BY A QUALIFIED

ELECTRICIAN ONLY.

ITEM NO.: RK33&RK33G

IMPORTANT SAFETY INSTRUCTIONS

Important:

When replacing Gu10 bulbs, be sure the Wattage of the bulb is 50W or less. Using higher wattage

bulb may damage the fixtures.

CAUTION:

To reduce the risk of fire, the bare conductors shall be installed a minimum 7 feet from the ground.

CAUTION:

Hot surface, keep away from curtains and combustible materials.

CAUTION:

Risk of burn, before energizing, ensure that the bare conductors are free from any metallic objects

not part of this lighting system.

When installing or using the lighting system, basic safety precautions should always be followed including the following.

1). Read all instructions.

2). Do not conceal or extend bus-bar conductors through a building wall.

3). Do not install this system in damp or wet locations.

4). Do not install any part of this system less than 7 feet above floor.

5). To reduce the risk of fire and overheating, make sure all connections are tight.

6). To reduce the risk of fire and burns, do not install this lighting system where the uninsulated open bus-bar

conductors can be shorted or contact conductive materials.

7). Turn off electrical power before modifying the light system in any way,or during re-lamping.

1 2 3 4 5

Summary of Contents

Page 1 - IMPORTANT SAFETY INSTRUCTIONS

*WARNING:RISK OF FIRE AND ELECTRIC SHOCK.THIS PRODUCT REQUIRES PROPER FIELD WIRING AND IS INTENDED TO BE INSTALLED BY A QUALIFIED ELECTRICIAN ONLY.ITE

Page 2

Caution: To reduce risk of fire, use only the type of lamp and maximum wattage marked on the fixturesCaution: To reduce risk of fire, do not use lamps

Page 3 - AT MAIN BREAKER

WARNING: TO PREVENT ELECTRICAL SHOCK TURN OFF POWER TO FIXTURE LOCATION Step2 : (2)Fasten cross bar (E) to junction box with screws(F).

Page 4 - ITEM NO.:RK33&RK33G

ITEM NO.:RK33&RK33Ginstalling rail to power feed and support the labelmust point towards the ceiling up"label is affixed to the top of the ra

Page 5 - B: Fixture Connections

Step6: Check for loose connections.1. Turn the power to electrical box on.